Technote (FAQ)
This document applies only to the following language version(s):
English
Question
Is there a way that you can set the tab size for the code editors per the IBM Rational Rhapsody install (globally) instead of per model?
Cause
In Rational Rhapsody, you can right-click in the implementation editor and set the tab size, fonts, etc (see below):
This setting is per model. If you wanted to set this for all models on the install then the below will provide the means.
Answer
The setting is controlled at the registry level and the following steps will allow you to set the tab size at the install level rather than per model.
WARNING: Always backup the registry before making any changes
1. Launch the registry editor
2. Open: HKEY_CURRENT_USER\Software\Telelogic\Rhapsody 7.6.1\Code Window-Ansi
3. Change the "TABSIZE" entry value
This solution contains information about modifying the system registry. Before making any modifications to the Microsoft Registry Editor, it is strongly recommended that you make a backup of the existing registry. For more information describing how to back up the registry, refer to Microsoft Knowledge Base article 256986 |
|---|
Rate this page:
Copyright and trademark information
IBM, the IBM logo and ibm.com are trademarks of International Business Machines Corp., registered in many jurisdictions worldwide. Other product and service names might be trademarks of IBM or other companies. A current list of IBM trademarks is available on the Web at "Copyright and trademark information" at www.ibm.com/legal/copytrade.shtml.