During installation of the APM UI install fails with deploy exit code 105

Technote (troubleshooting)


Problem(Abstract)

During installation of the APM UI, the install fails due to exception received while running deployapmui.jacl script and deployment fails with exit code 105.

Symptom

During APM UI installation, following error occurs:

*******************APMUI Deploy********************
EXECUTE_STDOUT_APMUI
------------------------------------------------------
WASX7209I: Connected to process "server1" on node TIPNode using SOAP connector;  The type of process is...
...
ADMA5005I: The application isc is configured in the WebSphere Application Server repository.
ADMA0185W: An update application operation failed and the configuration session could not be restored to its state before the operation was initiated.  The configuration session is in an inconsistent state, and changes made in the session should be discarded.
ADMA5011I: The cleanup of the temp directory for application isc is complete.
Update of isc has ended.
WASX7017E: Exception received while running file "/tmp/deployapmui.jacl"; exception information: com.ibm.ws.scripting.ScriptingException: WASX7418E: Application update for isc failed: see previous messages for details.
 
WASX7341W: No "save" was performed before the interactive scripting session exited; configuration changes will not be saved.
 
EXECUTE_STDERR_APMUI
------------------------------------------------------ 
EXECUTE_EXITCODE_APMUI
------------------------------------------------------
105

Cause

This may be caused by multiple module updates to isc application resulting in inconsistent state in WebSphere.

Resolving the problem


1. Start wsadmin session for the WebSphere, and run following command:

$AdminApp listModules isc

Make sure the apmTIP.war is NOT shown in returned list.

If apmTIP.war is listed in the returned list, then remove it by executing following commands in wsadmin session:

i) Discard any unsaved configuration changes:
$AdminConfig reset

ii) Delete existing apmTIP.war:

$AdminApp update isc modulefile {-operation delete -contenturi apmTIP.war}

iii) Save changes:
$AdminConfig save

iv) To end wsadmin session use exit command.

2. Run tipcli.sh Unlock --username tipadmin --password tippass
3. Re-install the APM UI.


Rate this page:

(0 users)Average rating

Add comments

Document information


More support for:

IBM SmartCloud Application Performance Management
IBM SmartCloud Application Performance Management UI

Software version:

7.5.0, 7.6.0

Operating system(s):

AIX, Linux/x86, Windows, Windows 7

Reference #:

1614853

Modified date:

2013-10-21

Translate my page

Machine Translation

Content navigation