Installing IBM Work Optimization for Water Utilities Fix Pack 1 on top of the IBM Intelligent Operations Center Version 1.0 Fix Pack 1

Preventive Service Planning


Abstract

If installing IBM Work Optimization for Water Utilities Version 1.0 Fix Pack 1 on top of the IBM Intelligent Operations Center Version 1.0 Fix Pack 1, an additional prerequisite step is required.

Content

Before you begin the installation of IBM Work Optimization for Water Utilities Version 1.0 Fix Pack 1, the Intelligent_Operations_Center.PO00013.fxtag file must be manually copied on to the IBM Intelligent Operations Center portal server.

Use the following procedure to copy the file, immediately after installing the prerequisite IBM Intelligent Operations Center Version 1.0 Fix Pack 1.

1) Log on to the IBM Intelligent Operations Center portal server as the administrator.

2) Open the directory /opt/IBM/iss/ioc.

3) Create a new folder called properties.

4) Open the properties folder and create a sub-folder called version.

5) Copy the Intelligent_Operations_Center.PO00013.fxtag file (attached to this technote) into the following directory:

/opt/IBM/iss/ioc/properties/version

Note: This step is not required if you are installing IBM Work Optimization for Water Utilities v1.0 Fix Pack 1 (1.0.0.1) on top of the previous version of IBM Intelligent Operations Center Version 1.0.

For more information about how to install the IBM Intelligent Operations Center Version 1.0 Fix Pack 1, see the IBM Intelligent Operations Center Information Center.

For more information about how to install IBM Work Optimization for Water Utilities Fix Pack 1, see the Intelligent Water Family Information Center.


Rate this page:

(0 users)Average rating

Document information


More support for:

IBM Intelligent Water
IBM Work Optimization for Water Utilities

Software version:

1.0.0

Operating system(s):

Linux Red Hat - xSeries

Reference #:

1588738

Modified date:

2012-10-11

Translate my page

Machine Translation

Content navigation