IO17877: FORM EDITOR MODE ISSUE
Fixes are available
Closed as program error.
After customizing a field on the form via the Form editor to specify a mode of visibility for a Field AND then removing the mode type the field is no longer visible in any mode. The expected result is that it should be reset to the default visibility for all modes. STEPS TO DUPLICATE: 1. Create a custom connector 2. Open with Form Editor 3. Add a Field, Set Mode Selection to AddOnly 4. and add to General form 5. Save and close 6. Add to an AL in various modes to test visibility. 7. Go back to the form editor and remove AddOnly 8. Save and Close 9. Go back to an AL and test, the field is no longer visible in any mode. The manual fix is to open the .connector and remove the line: <parameter name="modes"/> from the definition: <FormItem name="filepath"> <parameter name="description">Enter path</parameter> <parameter name="label">Path</parameter> <parameter name="modes"/> </FormItem> Desired Behavior: Form Mode is managed correctly after changes in visibility from the Form Editor. Environment: TDI 7.0. fp 6 (and later) Note this fix needs to be applied to 7.0 and later.
Form mode should behave properly.
This is a bug in the TDI Code and has been fixed. The official fix will be made available in 7.1.1-TIV-TDI-FP0003.
Reported component name
Reported component ID
Last modified date
APAR is sysrouted FROM one or more of the following:
APAR is sysrouted TO one or more of the following:
Fixed component name
Fixed component ID
Applicable component levels
Translate this page: