Installing Only the IBM AFP Workbench Viewer Components on a Microsoft Windows PC

Technote (troubleshooting)


Problem(Abstract)

Installing only the AFP Workbench Viewer Components can be done by running Selective Setup of IBM iSeries Access 400 for Windows (5722XE1).

Resolving the problem

Installing only the AFP Workbench Viewer Components can be done by running Selective Setup of IBM iSeries Access 400 for Windows (5722XE1). There is not a Selective Setup option using System i Access R610. In order to add or remove components on 610, you must go to the control panel of the PC, select Add/Remove Programs, Select IBM System i Access for Windows, and then Change.

Caution: Follow the iSeries Access 400 Installation Guide for complete installation instructions.

Select only the following components in the Component Selection window (see below for screen prints with selections):
o Required programs
o iSeries Navigator
-- iSeries Navigator Base Support
-- Basic Operations
-- AFP Manager
o Data Access
-- ODBC
o AFP Workbench Viewer
o Toolbox for Java

After the base code has been installed, apply the latest Service Pack for iSeries Access 400.

This picture displays the initial Component Selection window of Selective Setup

This picture further displays the Component Selection window, paged down.

This displays the AFP Manager component with a check mark to select it.

This displays the Component Selection window with ODBC selected.

This displays the Component Selection window with AFP Workbench Viewer and Toolbox for Java selected.

Historical Number

333377401

Rate this page:

(0 users)Average rating

Add comments

Document information


More support for:

IBM i
Print

Software version:

5.3.0, 5.3.5, 5.4.0, 5.4.5, 6.1, 6.1.0, 6.1.1

Operating system(s):

IBM i

Reference #:

N1016151

Modified date:

2012-08-18

Translate my page

Machine Translation

Content navigation