PM54931: DT READS SYSDEBUG THRU SET DEFAULT LISTING INSTEAD OF EQAUEDAT

APAR status

• Closed as duplicate of another APAR.

Error description

• "SET DEFAULT LISTING .." is taken into consideration before
  EQAUEDAT When DT reads the separate debug file. This conflicts
  the precedent rule mentioned in DT User's Guide.
  
  "How does Debug Tool locate COBOL and PL/I separate debug file
  files?
  Debug Tool might read from a COBOL or PL/I separate debug file
  more than once but it always reads the separate debug file from
  the same data set. After Debug Tool locates a valid separate
  debug file, you cannot direct Debug Tool to a different
  separate debug file. When the CU first appears, Debug Tool
  looks for the separate debug file in the following order:
  1. SET SOURCE command
  2. default data set name. If the EQAUEDAT user exit is
     implemented and a EQADEBUG DD statement is not specified,
     the data set name might be modified by the EQAUEDAT user
     exit.
  3. SET DEFAULT LISTINGS command. If the EQAUEDAT user exit is
     implemented and a EQADEBUG DD statement is not specified, the
     data set name might be modified by the EQAUEDAT user exit.
  4. if present, the EQADEBUG DD statement The SET SOURCE command
     can be entered only after the CU name appears as a CU and the
     separate debug file is not found in any of the other
     locations.
  The SET DEFAULT LISTINGS command can be entered at any time
  before the CU name appears as a CU or, if the separate debug
  file is not found in any of the other possible locations, it
  can be entered later."
  

Local fix

Problem summary

Problem conclusion

Temporary fix

Comments

• Please install UK75928 to receive the solution for
  this APAR.
  This APAR is a duplicate of PM54307
  

APAR Information

• APAR is sysrouted FROM one or more of the following:

• APAR is sysrouted TO one or more of the following:

Fix information

Applicable component levels