Fujitsu ETERNUS LT S2 Library Configuration Information for IBM Tivoli Storage Manager Server

Preventive Service Planning


Abstract

Configuration Information for Fujitsu ETERNUS LT S2 Tape Libraries

Content


Fujitsu ETERNUS LT20 S2
Fujitsu ETERNUS LT40 S2
Fujitsu ETERNUS LT60 S2

1. Maximum library capacity is supported.

2. Starting element addresses

  • Drive - 1
  • Storage Slot - 1001
  • Entry/Exit port - 101
  • Robot - 0

3. Eight character barcodes are required. The last 2 characters must be the media identifier "Lx" where x is the tape cartridge generation. For example, ABC456L5 for an LTO-5 cartridge. Without a proper barcode label, a volume will appear as "unknown media".

4. Cleaning cartridge can be identified if the barcode label starts with the three characters “CLN”, for example “CLN007L2”.

5. Fujitsu ETERNUS LT S2 is not supported with Tivoli Storage Manager Management Console. Use Administration Center or the TSM Server commands to define the library and label tapes.

6. ELEMent=AUTODetect in the DEFINE/UPDATE DRIVE command is supported.

7. The Fujitsu ETERNUS LT S2 tape library family does not support a mix of different tape drive technologies, but it supports a mix of different LTO media generations within a (logical) tape library. Tivoli Storage Manager Server supports a mix of different LTO media generations up to generation 5. See Libraries with Mixed Media Capability for more information.

8. The Fujitsu ETERNUS LT S2 tape library family is available with the following drives.
9. For devices with SAS interface, see Technote 1396706 for information on platforms on which SAS devices are supported.

10. Device identifications and firmware levels used during validation with TSM 6.2.4.
    Fujitsu ETERNUS LT20 S2
    Library ID : FUJITSU ETERNUS LT S2 --- Firmware : 1.83
    Drive ID : HP Ultrium 5-SCSI --- Firmware : Z58B (HH SAS)
    Fujitsu ETERNUS LT40 S2
    Library ID : FUJITSU ETERNUS LT S2 --- Firmware : 4.63
    Drive ID : HP Ultrium 5-SCSI --- Firmware : Y5AB (HH FC)
    Fujitsu ETERNUS LT60 S2
    Library ID : FUJITSU ETERNUS LT S2 --- Firmware : 4.63
    Drive ID : HP Ultrium 5-SCSI --- Firmware : I5BB (FH FC)
    Fujitsu ETERNUS LT60 S2
    Library ID : FUJITSU ETERNUS LT S2 --- Firmware : 4.63
    Drive ID : HP Ultrium 5-SCSI --- Firmware : X59B (FH SAS)



Library and drive may require different minimum Tivoli Storage Manager levels. Therefore, ensure that both library and drive hardware are supported. See " Supported Devices for AIX, HP-UX, Solaris and Windows" or " Supported Devices for Linux" for more support information including minimum supported version levels and supported platforms.

More information regarding device configuration is available in the Tivoli Storage Manager Administrator's Guide, which can be found in the IBM Tivoli Storage Manager information center.

Rate this page:

(0 users)Average rating

Document information


More support for:

Tivoli Storage Manager
Server

Software version:

All Supported Versions

Operating system(s):

AIX, HP-UX, Linux, Solaris, Windows

Reference #:

1575258

Modified date:

2014-12-16

Translate my page

Machine Translation

Content navigation