IBM Support

IV52126: USER CAN INSERT A NEW CAL POINT ON A WORKORDER DATASHEET ON WORKORDER COMPLETE STATUS

Subscribe

You can track all active APARs for this component.

 

APAR status

  • Closed as program error.

Error description

  • Maximo allows user to insert a new cal Point on a WorkOrder
    Datasheet
    even when work order is in a completed status
    .
    Problem description
    Maximo should not allow a user to add a cal point to the work
    order
    data sheet when the WO is in completed or equivelant status and
    it
    currently is allowing you to.  It does not allow the user to
    take any
    data for this newly added point therefore it should not allow
    you to
    create a new cal point at this point in the process (status =
    comp).
    
    Steps to re-create:
    Go to a CAL Type Work Order that contains a data sheet and is in
    COMP
    or equivelant status.  Go to Data Sheet tab of work order, cal
    point
    section and select new row.  The system should not allow the
    user to
    add a new cal point to a completed work order.
    
    Tested on 7.5.0.3 and 7.5.0.5
    
    Please note that configuration setting for Edit Cal Point for
    COMP status is set to ?0? already.
    
    Same results
    

Local fix

Problem summary

  • ****************************************************************
    * USERS AFFECTED:                                              *
    * Maximo Users on Calibration                                  *
    ****************************************************************
    * PROBLEM DESCRIPTION:                                         *
    * On Completed Workorders, users are allowed to insert a new   *
    * cal point                                                    *
    ****************************************************************
    * RECOMMENDATION:                                              *
    * Apply fixpack 7.5.0.6 of Base Services or request interim    *
    * fixes                                                        *
    ****************************************************************
    

Problem conclusion

  • On completed workorders with datasheets, cal point are not
    allowed
    
    The fix for this APAR is contained in the following maintenance
    package:
    	 | release\fix pack\interim fix for Release 7.5.0.6 of Base
    Services
    

Temporary fix

Comments

APAR Information

  • APAR number

    IV52126

  • Reported component name

    MAXIMO CALIBRAT

  • Reported component ID

    5724R5700

  • Reported release

    750

  • Status

    CLOSED PER

  • PE

    NoPE

  • HIPER

    NoHIPER

  • Special Attention

    NoSpecatt / Xsystem

  • Submitted date

    2013-11-15

  • Closed date

    2014-03-09

  • Last modified date

    2014-03-09

  • APAR is sysrouted FROM one or more of the following:

  • APAR is sysrouted TO one or more of the following:

Modules/Macros

  • MAXIMO
    

Fix information

  • Fixed component name

    MAXIMO CALIBRAT

  • Fixed component ID

    5724R5700

Applicable component levels

  • R750 PSY

       UP

[{"Business Unit":{"code":"BU059","label":"IBM Software w\/o TPS"},"Product":{"code":"SSLKZS","label":"Maximo Calibration"},"Component":"","ARM Category":[],"Platform":[{"code":"PF025","label":"Platform Independent"}],"Version":"750","Edition":"","Line of Business":{"code":"LOB59","label":"Sustainability Software"}}]

Document Information

Modified date:
15 November 2022