WebSphere CloudBurst Appliance

Purpose:

• Use this set of prerequisites to plan for installation, configuration and use of WebSphere CloudBurst Appliance.

Information required:
You need to collect the following data to define your WebSphere CloudBurst base configuration.

• The IP address and subnet mask for the Ethernet interface for appliance management access

• The IP address of the default gateways (routers) that supports the subnets for the Ethernet interfaces

Best Practice:
Use the remaining three Ethernet interfaces to handle data traffic to and from the various hypervisors.

Optional:
The IP addresses and subnet mask for Ethernet interfaces for appliance service access (ETH0, ETH1, and ETH2) MGMT Ethernet interface on a dedicated subnet for all network- and system-wide management functions. This dedicated subnet would handle network traffic for Web Management (WebGUI) functions.

Setup and physical installation perquisites:
You need to collect the following data to configure your WebSphere CloudBurst environment.

The WebSphere CloudBurst appliance is a 1U rack-mountable network appliance. You can install the appliance in a standard 19 inch (48.26 cm) rack with a minimum of 25 inches (63.5cm) of depth. When planning the installation, keep the following in mind: v The rack must provide rear mounting columns. The appliance requires both front and rear mounting support. v There must be at least 30 inches (76.20 cm) of free space behind the rack frame to remove replaceable parts. v The ambient temperature in the operating environment and within the rack should not exceed 104° F (40° C). v Leave at least 2 inches (5.1 cm) above and below the appliance to provide adequate ventilation and to assist in appliance maintenance. v The rack must provide sufficient free space in the front for the Ethernet cables and any serial console cable.

You will need the following tools, hardware, and cables to install the WebSphere CloudBurst rack-mounting kit: v A medium Phillips screwdriver v Two (2) standard rack screws You will need the following cables to connect the WebSphere CloudBurst appliance to your network: v At least one (1), but up to four (4), network cables.

To perform the initial configuration, you must use a serial connection. The serial connection must be between an ASCII terminal or a PC running terminal emulation software to the serial port on the appliance. To make this connection, use the provided DB-9 null-modem cable. Note: If the terminal or PC is not equipped with a serial port, use a USB-to-serial converter cable (not provided).